How can I edit lettering so that it is at an angle and sort of popping out of the page? I don't mean just 3D lettering. I mean putting the lettering at an angle so that the letters to the left look smaller and recede, and the letters to the right look closer and bigger, as if the whole line were a 3D shape, receding perspectivally?
1 Community Answers
Hello there Jeanne-Marie,
Thanks for contacting us.
Once you have dropped in some Lettering, click off it, then click on it once, then click on it again. (Not a double click, two single clicks).
It will then enter a mode where you can warp the lettering. You will get the same handles you see when editing a panel shape.
Then move the handles to make it look the way you want.
Hope this helps!
This question has received the maximum number of answers.