Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB

Manipulating lettering

Jeanne-Marie Baron Jan 07, 2015 11:36PM AEDT

How can I edit lettering so that it is at an angle and sort of popping out of the page? I don't mean just 3D lettering. I mean putting the lettering at an angle so that the letters to the left look smaller and recede, and the letters to the right look closer and bigger, as if the whole line were a 3D shape, receding perspectivally?

1 Community Answers

Best Answer
Mark | plasq support Jan 08, 2015 12:49AM AEDT

Hello there Jeanne-Marie,

Thanks for contacting us.

Once you have dropped in some Lettering, click off it, then click on it once, then click on it again. (Not a double click, two single clicks).
It will then enter a mode where you can warp the lettering. You will get the same handles you see when editing a panel shape.
Then move the handles to make it look the way you want.

For example:

Hope this helps!


This question has received the maximum number of answers.

Contact Us

  • For a direct and personal response from the plasq support elves:
    Send us an email
    (Perfect for questions relating to serials and registration, and other questions in this realm)

  • For application specific help, tips and tricks (and not registration related):
    Post a community question
plasq@plasq.com
http://assets1.desk.com/
false
assistly
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete